Bypass the key switch if it doesnt light. In the running lights position you should have continuity between 2. If the atv is in neutral, the green light should go on when you turn the key. For the three position, 3 wire, you should find that in the headlights on position you have continuity between all wires. Watch the video to see how it was all installed, only 3 bolt. In the simple on/off 2-wire you'd look for continuity between the 2 wires with the switch on, none when off. Well after I replace all the pieces bought from Goofit, found out it was just my ignition wires. Sometimes there is a third wire for the tail light or running lights as well or even multiple positions, off, running lights, headlights. For that there will be a power in and power out. If you do have an on/off switch it should be on the right side controls on the hbars. The hi/lo beam switch should be on the left side control assembly on your bars.Ī lot of scoots don't have an on/off switch for the headlights and simply come on whenever there's power (scooter is running). I forget the color in, and it varies anyway, maybe yellow? At any rate you should fine that either of the wires out of the switch to the lights would have power if the switch is in the right position, or should have continuity with the power supply wire into the switch when in the right position. Please read carefully before operating this vehicle This vehicle should only be assembled and prepped by an authorized Tao Motor Dealer or professional motorcycle mechanic. Usually it's either light blue and blue or white and blue out of the switch. D125,T125 Owner’s Manual READ THIS MANUAL CAREFULLY It contains important safety and service information. The switch will determine which of the 2 other wires have power.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |